5V/12V/24V Single Bond Button Bistable Relay Module Modified Car Start And Stop Self-Locking Switch One Key - Price History & Review | AliExpress Seller - JIAQISHENG DIY Module Store

About This Product

Life expectancy: 1 million times Supply voltage: 5V Supply current: more than 100mA Bistable Relay Module 5V 12V Single Button Relay Module One Key Car Modification Start-Stop Self locking Car Modification Switch 5V/12V/24V Single Bond Button Bistable Relay Module Modified Car Start And Stop Self-Locking Switch One Key - Price History & Review | AliExpress Seller - JIAQISHENG DIY Module Store Double Panel Self-Locking Switch Module Single Bistable SCM Relay Load: 250V 10A (AC) or 30V 10A (DC) The relay is off when the power is turned on again.3.The maximum withstand current of the secondary output of the relay is 10A, which means that the maximum working current of the controlled circuit or device cannot be greater than 10A, and it is connected to the normally open end or normally closed end according to its own needs.4.The welding position of the external pull-in indicator is reserved, and there is also a welded pull-in indicator on the board Note: One-key two-state relay module, the power supply will be burned when the positive and negative connections are reversed, and there is no power reverse protection Low level control It is a trigger signal when the signal line touches the ground Product Paramenters Power supply voltage 12V Supply current greater than 100mA Load 250V 10A (AC) or 30V 10A (DC) Life 1 million times Product instructions 1.Connect the corresponding direct power supply according to the voltage version; 2.The power supply can not be reversed according to the requirements of the wiring diagram. Product Usage: Press the trigger button, the relay pull lock, press again, the relay is disconnected, you can also contact the trigger switch, and trigger with a low level. DC 12V 5 Channel Self-Locking Relay odule, Latch Relay 10A High Low... If you have any question, please contact us. Although there is a protection circuit, it cannot be reversed for a long time; 3.The product uses a voltage regulator tube (5V without a voltage regulator tube), it is normal to have a slight fever, and the relay also has a normal heating phenomenon when it works for a long time, which is normal; 4.The load power should leave a certain margin for the relay load.